ISTech Support Forum

ISTech Support Forum
http://www.istechforum.com/YaBB.pl
Evo-ERP and DBA Classic >> Evo Menu & Evo-ERP >> Modifying T6....RTM
http://www.istechforum.com/YaBB.pl?num=1052942414

Message started by HB on 05/14/03 at 14:00:14

Title: Modifying T6....RTM
Post by HB on 05/14/03 at 14:00:14

I am trying to modify the packing list RTM T6soc4.rtm and whenever I add a new datafield and save, a trial print under TAS6EVO fails to show the list screen after going through the setup of the packing slip screen in
SO-C. I have to restore a backup version to get it back.
I am particularly interested in printing a UPC code and tried to select the data field in the inventory master that contains the code.

Title: Re: Modifying T6....RTM
Post by David Waldmann on 05/15/03 at 06:26:50

The worst success I've had is that the new data field just doesn't show up. What exactly is happening?

I'm assuming that you are calling T6SOC.RUN (not BKSOC.RUN), and that you have the TASPRO6 Enduser Editor.

Title: Re: Modifying T6....RTM
Post by HB on 05/15/03 at 07:27:18

after modification (adding a datafield like the barcode) and saving I tried to print a packin listfrom the TAS6EVO screen. It shows the setup screen for the P/S print and i went through all the parameters. At the it showed me the little screen that gives me the choice of RTM and after that nothing happened.
Yes, I am using the TAS6 version of form editor and T6SOC4.RTM