ISTech Support Forum

ISTech Support Forum
http://www.istechforum.com/YaBB.pl
Evo-ERP and DBA Classic >> Items >> Returned & Reworked
http://www.istechforum.com/YaBB.pl?num=1054240011

Message started by benp on 05/29/03 at 14:26:51

Title: Returned & Reworked
Post by benp on 05/29/03 at 14:26:51

Our customer returned (10) Sub-assemblies to be reworked. We did a negative item on the original SO to add the returned items back into inventory and we are using a new SO for the "new" items.

We now have (10) items on-hand (the returned items). On a normal job we usually would WO-I to enter the items into finished production, but that would give us an extra (10) items in inventory.

How do we use the (10) returned items w/o adding (10) more to finished production?

Title: Re: Returned & Reworked
Post by Lynn_Pantic on 05/29/03 at 15:19:48

Open a work order for 10 of the item. Use WO-K-B and edit the BOM to remove the normal components used for production. Issue the 10 returned parts to the work order. While a part can not be entered on its own master BOM, it CAN be issued to a work order for itself. Then add the cost of the rework labor and any components used in the rework and then WO-I and ship.

One caution to using this method. If you use the same part number as the original item and you also have good parts in stock, the costing will average the good and reworked parts. If that is the case, you may need to create a new part number for the reworked parts (same part number with an R at the end or something), then open a WO for the R part and issue the 10 returned parts to it. WO-I and invoice the R part.