ISTech Support Forum

ISTech Support Forum
http://www.istechforum.com/YaBB.pl
Evo-ERP and DBA Classic >> Problem Reports - Repeatable >> Printing SO acknowlegements in EVO-ERP
http://www.istechforum.com/YaBB.pl?num=1114789507

Message started by Vman on 04/29/05 at 07:45:07

Title: Printing SO acknowlegements in EVO-ERP
Post by Vman on 04/29/05 at 07:45:07

I am setting up EVO-ERP with the latest updates.
When I print a acknowlegement using SO-B, it defaults to the "T6" version of the default .RTM and prints fine.
If I try to print a acknowlegment from the PRINT button in SO-A, it defaults to the "non-T6" version of the .RTM and then displays a warning error of
The Report File Name: H\DBAMFG\c{two squares}
Pressing the OK button aborts the printing. If you try to change the form to the "T6" version, it still errors.
BTW, is there any way to change the defaults forms in SD to other than the standard "non-T6" forms?

Title: Re: Printing SO acknowlegements in EVO-ERP
Post by NovaZyg on 04/29/05 at 09:11:12

It sounds like you need to run the "T6MENUUTIL.RWN" This converts all the user menus to call the correct T6 programs not the old BK ones.

UT-A T6menuutil

Title: Re: Printing SO acknowlegements in EVO-ERP
Post by Vman on 04/29/05 at 11:42:16

Thanks, that did the trick. Was this something I was supposed to do when I installed EVO-ERP? I didn't see anything in the installation instructions about this.

Now on to the next problem.. When I print an acknowlegement with an assembly that was created using Features and Options, it prints the comment lines that were entered after the assemnbly before the actual assembly line item.