ISTech Support Forum

ISTech Support Forum
http://www.istechforum.com/YaBB.pl
Evo-ERP and DBA Classic >> Problem Reports - Repeatable >> W/O issues being rounded
http://www.istechforum.com/YaBB.pl?num=1127832888

Message started by Vman on 09/27/05 at 06:54:48

Title: W/O issues being rounded
Post by Vman on 09/27/05 at 06:54:48

We have a component of an assembly that we use 1.083 feet of (13 inches- it's stocked in feet). When we go to close a work order for the item and backflush the materials, we get an error message that not all materials have been issued for the work order.
This is due to the fact that the backflush rounds the materials to 2 places past the decimal (1.08 vs 1.083). If you use WO-G to issue the materials, then you can the full amount issued.
It also appears that inventory transactions may be limited to 2 places as well (at least what is displayed in IN-A).

Title: Re: W/O issues being rounded
Post by David Waldmann on 09/28/05 at 03:55:42

You may be able to issue to three or four decimal places in WO-G, but WOMAT only records to two decimal places (even though four places show in the database and you can manually enter four places in Maintain Database). It can be a real annoyance sometimes.