ISTech Support Forum

ISTech Support Forum
http://www.istechforum.com/YaBB.pl
Evo-ERP and DBA Classic >> Problem Reports - Repeatable >> Cannot access Forms Editor in DBA Classic
http://www.istechforum.com/YaBB.pl?num=1131634314

Message started by John_Wilkinson on 11/10/05 at 06:51:54

Title: Cannot access Forms Editor in DBA Classic
Post by John_Wilkinson on 11/10/05 at 06:51:54

I get Runtime Error 216 whenever I try to run the forms editor in DBA Classic. I had to reinstall DBA a couple months ago and ever since I get this error message. Maybe the forms editor program is missing or corrupted. What is the program name and can I replace it? Any other suggestions?

John

Title: Re: Cannot access Forms Editor in DBA Classic
Post by JNAPIER on 11/10/05 at 07:21:22

Classic calls ENDUSER for the forms editor.

John

Title: Re: Cannot access Forms Editor in DBA Classic
Post by Lynn Pantic on 11/10/05 at 07:47:08

It is actually embedded within the TP5WDBA.EXE. There should be a backup coipy of the EXE on your CD.

Title: Re: Cannot access Forms Editor in DBA Classic
Post by John_Wilkinson on 12/02/05 at 08:19:40

I recently installed the complete version of the 9/25 update hoping that this may correct the problem. It did not but, I now get a general protection fault error instead of the timeout error when ENDUSER tries to load in both Classic and Evo.

You indicated that the forms editor was imbedded in Tp5wdba.exe so I replaced the Tp5wdba.exe in the DBAMFG folder with a copy from the orignial CD as you suggested but that didn't help.

I noticed that ENDUSER.EXE is also in the DBAMFG folder as a separate program. Should it be in both places?