ISTech Support Forum

ISTech Support Forum
http://www.istechforum.com/YaBB.pl
Evo-ERP and DBA Classic >> Manufacturing >> reorder report
http://www.istechforum.com/YaBB.pl?num=1141925209

Message started by dlindeman on 03/09/06 at 09:26:49

Title: reorder report
Post by dlindeman on 03/09/06 at 09:26:49

I'm hoping that someone can help me with this problem that we are having. We run the reorder report it does not include all the part numbers that are below the reorder level. If we go into that partnumber and look at it the next time we run the reorder report it will appear then. (we know that partnumber is getting low that is why we check it becuae it is not on the reorder report and have gotten burned before). Do you have any suggestions? Does this happen to anyone else?? This has been going on for sometime now. Have sent copies to Lynn and showed her what is happening. Thought I would check this out also and see if anyone else has suggestions? Thanks!!
Diana
Delta Fabricating

Title: Re: reorder report
Post by Tim Keating on 03/09/06 at 11:39:07

Are you answering Yes to Rebuild Stock Status Fields?

Title: Re: reorder report
Post by dlindeman on 03/10/06 at 09:20:31

No we are not saying yes to rebuild stock status because it takes hrs to run.

Title: Re: reorder report
Post by timgolds on 03/10/06 at 09:25:42

Diana,

It happens to us as well. We rebuild stock status every morning to fix it.

I have also mentioned to Lynn in Phoenix about this problem.

Tim

Title: Re: reorder report
Post by Tim Keating on 03/10/06 at 10:26:17

Diana:

As you've noticed, doing a screen inquiry in IN-A will cause the data to update for that part.

Rebuilding Stock Status or running SM-J-C Master Level Reconcilliation will do it system wide but that is time consuming as you said.

This is a known issue and hopefully will be tackled soon.

In my opinion, spending programming time on a structural issue like this is more important than some of the cosmetic improvments I've seen.

I'm sure it isn't as much fun though.