ISTech Support Forum

ISTech Support Forum
http://www.istechforum.com/YaBB.pl
Evo-ERP and DBA Classic >> Problem Reports - Repeatable >> IN-B Revision level and UPC fields being skipped
http://www.istechforum.com/YaBB.pl?num=1173215685

Message started by kevind on 03/09/07 at 12:12:44

Title: IN-B Revision level and UPC fields being skipped
Post by kevind on 03/09/07 at 12:12:44

When entering a new item, or editing an existing Item, the following fields:
Revision level
UPC
Are skipped.

Pressing Enter after entering the 'Drawing' field results in the cursor jumping down to the 'Warehouse Control?' field.

Also, the title of the window truncates the ISTS Enhancement date in some cases. When editing an item, IN-B currently reads:
'IN-B Enter Inventory - Edit Existing Item Number - ISTS Enhancement 0'

I would vote to remove the word 'Enhancement' from the Titles; just leave 'ISTS mm/dd/yy'.

BTW: The popup window that displays after selecting 'Part Type' is kind of goofed up. It looks like it is missing it's bottom edge.

Title: Re: IN-B Revision level and UPC fields being skipp
Post by NovaZyg on 03/09/07 at 14:21:44

Kevin,

UPC is an addon.. it is not a field you have ever had access to.

Rev level: I suspect you have ECO turned on, So Drawing and Rev Level are controlled by the ECO system, Press F2 on the Drawing field.

The Type "N" part that brings up the Multi Yeild and Service/Repair question was off so i just fixed it Thank you.

And I trimmed the Program Header to include the Date of the ISTECH changes. Thank you again.

Title: Re: IN-B Revision level and UPC fields being skipp
Post by kevind on 03/09/07 at 15:28:21

Thank you Allen for clarifying these fields for me. We do have ECO turned on.

We never used the UPC field, I was formally posting a Complaint (http://www.istechforum.com/cgi-bin/YaBB.pl?num=1173212722/0#0) (as a courtesy) were it would get some attention.