ISTech Support Forum

ISTech Support Forum
http://www.istechforum.com/YaBB.pl
Evo-ERP and DBA Classic >> Problem Reports - Sporadic >> WO-A FATAL ERR- File: WBKLOOKUP.SRC Line 1673
http://www.istechforum.com/YaBB.pl?num=1239298241

Message started by awaretech on 04/09/09 at 10:30:41

Title: WO-A FATAL ERR- File: WBKLOOKUP.SRC Line 1673
Post by awaretech on 04/09/09 at 10:30:41

A couple of my users are getting a sporadic error when doing a drill-down in WO-A. They get two error messages:

WO-A FATAL ERR- File: WBKLOOKUP.SRC Line 1673
There is a fatal problem with the following expression. The problem may have to do with parentheses: "All" = "All".A.WOBOM.WOPRE = VAL(82810) .A. WOBOM.WOSUF=INT(VAL(2))

followed by:

FATAL ERR - File: LISTG60.LIB Line: 210
The field you are trying to use is unallocated. It may belong to a file that hasn't been opened yet, or was an array that was removed from memory - TEMPO

It doesn't happen every time, and it doesn't necessarily happen on the same work order if they go right back in and try again.

Title: Re: WO-A FATAL ERR- File: WBKLOOKUP.SRC Line 1673
Post by Lynn_Pantic on 04/09/09 at 11:32:01

Do you have quotation marks in any of your part numbers? That can cause problems with drill downs.

Title: Re: WO-A FATAL ERR- File: WBKLOOKUP.SRC Line 1673
Post by awaretech on 04/09/09 at 12:48:06

We do have some, yes, usually when indicating inches. We also use other special characters, such as # and * . Can these cause problems as well?

Title: Re: WO-A FATAL ERR- File: WBKLOOKUP.SRC Line 1673
Post by skyywalker on 04/09/09 at 13:50:20

Yes, they can cause problems too and will appear to be sporadic depending on the context.

Title: Re: WO-A FATAL ERR- File: WBKLOOKUP.SRC Line 1673
Post by awaretech on 04/09/09 at 14:07:49

I should clarify: our part numbers do not have any special characters, but the part number descriptions might. Is it just if those characters are in the actual number that there could be a problem?

Title: Re: WO-A FATAL ERR- File: WBKLOOKUP.SRC Line 1673
Post by NovaZyg on 04/09/09 at 23:32:02

You can't have ' or " as characters in a part number but as far as I remember # and * are ok

Anything can be in the Descriptions.