ISTech Support Forum

ISTech Support Forum
http://www.istechforum.com/YaBB.pl
Evo-ERP and DBA Classic >> Manufacturing >> Wc-C UOH Entry issue
http://www.istechforum.com/YaBB.pl?num=1257779819

Message started by gtladmin on 11/09/09 at 08:16:59

Title: Wc-C UOH Entry issue
Post by gtladmin on 11/09/09 at 08:16:59

Walter tells me this issue is present:

Quote:

WC-C , Assign Bin to Location. Warehouse on hand for 4115 is 82, I tried to enter the UOH for the bin to match Warehouse on hand and it will not allow the entry. Sometimes it does, sometime it doesn't. Like seiral control and Lot control, Bins need to be re-aligned with on hand inventory.

It doesn't seem to matter whether I change Warehouse Control to Q or Y, it will not allow the entry.

Walter

Anyone have any assistance for Walter?

Val

Title: Re: Wc-C UOH Entry issue
Post by Lynn_Pantic on 11/09/09 at 10:21:12

It should allow the entry if the part is set for Q for that Warehouse Location. It needs to be the Location specific setting, not the Master setting.

Title: Re: Wc-C UOH Entry issue
Post by gtladmin on 11/10/09 at 10:44:37

Thanks, Lynn. I will run this by Walter and if I have time I will test myself, too.

Val