ISTech Support Forum http://www.istechforum.com/YaBB.pl Evo-ERP and DBA Classic >> Source Code and Programming in TAS >> Start Stop times for labor posting... http://www.istechforum.com/YaBB.pl?num=1093967289 Message started by ITman on 08/31/04 at 07:48:09

Title: Start Stop times for labor posting... Post by ITman on 08/31/04 at 07:48:09 We have been running barcode labor collection here for testing for a little while now.  The scanners put all the nessesary data into BKDCPLAB and then we make some corrections at the end of the day if needed and post labor.  Now we are looking to be able to print a report on what was done and when.  However, when we post labor the start time and stop times from the labor transactions in BKDCPLAB are errased when DBA/Evo transfers them to WOLABOR.  If I look in WOLABOR using maintain database the start and stop times are all 00:00:00.   Is the information stored anywhere else, or an option to turn on?  The data is there when in BKDCPLAB from the barcode scanners.  And the same thing happens if I use WO-M Batch labor entry then post.  Is this the same for everyone else?

Title: Re: Start Stop times for labor posting... Post by aricon on 08/31/04 at 08:50:42 Can't remember for sure, but did you look in BKDCLAB for the start and stop times?

Title: Re: Start Stop times for labor posting... Post by Lynn Pantic on 08/31/04 at 09:01:17 Lorne is correct, the posted labor is stored in BKDCLAB with start and stop times.  DC-D for Posted Labor is the standard DBA report that uses that file.

Title: Re: Start Stop times for labor posting... Post by ITman on 08/31/04 at 09:28:55 Bingo!  That's what I was looking for. Much thanks, Keith

ISTech Support Forum » Powered by YaBB 2.1! YaBB © 2000-2005. All Rights Reserved.