ISTech Support Forum

ISTech Support Forum
http://www.istechforum.com/YaBB.pl
Evo-ERP and DBA Classic >> Manufacturing >> WO-M not jiving
http://www.istechforum.com/YaBB.pl?num=1469466507

Message started by Laura Oliver on 07/25/16 at 10:08:27

Title: WO-M not jiving
Post by Laura Oliver on 07/25/16 at 10:08:27

Our time clocks are in base 100 not base 60. 16:75 is better known as 4:45 pm.
In the past we have entered labor time manually via WO-F (enter Labor). JC-C is printed as confirmation and it comes out pretty close to the time card.

On occasion I have tried to use Wo-M (batch entry labor) but the time is horribly always off.
I really dont think its a conflict of base 10/base 60 . I am not sure what it is.

example from time card example from WO-M
start 6:21 start 6:21
end 7:81 end 7:81
total .90 correct total .83 wrong

start 9:73 start 9:73
end 10:79 end 10:79
total 1.06 correct total .1.10 wrong

Is there a default that would cause WO-F to work friendly with JC-C? Or be closer to real time?

Thanks,
Laura

Title: Re: WO-M not jiving
Post by Lynn_Pantic on 07/26/16 at 14:37:05

WO-M if you enter start and stop time is assuming HH:MM:SS, not decimal time. You can skip the start & stop and just enter the elapsed time (same as WO-F).