ISTech Support Forum

ISTech Support Forum
http://www.istechforum.com/YaBB.pl
Evo-ERP and DBA Classic >> Manufacturing >> PO-D PO Receiver # doesnt jive with PO-I-E
http://www.istechforum.com/YaBB.pl?num=1662678113

Message started by Laura Oliver on 09/08/22 at 16:01:53

Title: PO-D PO Receiver # doesnt jive with PO-I-E
Post by Laura Oliver on 09/08/22 at 16:01:53

I have a problem so I changed the look up grid in PO-D so that I could see the receiver number that is auto assigned by EVO. For this particular PO we should have just had one receiving line. But PO-D shows we had 4 different receipts. Only the first line is correct. I am not sure how we got the 3 next receiver numbers for this PO but I think it is because I have a new helper.

I would think the lines in PO-D should match PO-I-E. Is that correct? I see 4 lines when I view PO=D but only 1 line when I view PO-I_E.

Also this is causing problems with AP-C because there are these other receipts showing up.

Also where can I find Purchase Order Receiver numbers other than the lookup grid in PO-D?

Thanks
Laura

Title: Re: PO-D PO Receiver # doesnt jive with PO-I-E
Post by Kelloggs on 09/09/22 at 09:17:43

As far as I can remember, there was not need to modify the PO-D grid
Remove any modification

Purchase Orders can have multiple receivers ...
Purchase Orders Lines can have multiple receivers ...

PO-D is the best window. That is why is called "View PO Receivers"

8-)

Title: Re: PO-D PO Receiver # doesnt jive with PO-I-E
Post by Laura Oliver on 09/12/22 at 13:56:14

I didn't modify the grid until after I discovered we had a problem. Modifying the grid allowed me to see the receiver number without having to slide over to the right.

My problem is that AP-C sees multiple receivers. So does PO-D. In this case PO-d is wrong. PO-I-E is accurate and shows only one receiver.