ISTech Support Forum - Bin Location

Welcome, Guest. Please Login.

	06/07/25 at 16:14:09 News: \| IS Tech Support \| Evo~ERP \| Evo Wiki \| Forum \|

ISTech Support Forum › Evo-ERP and DBA Classic › Items

‹ Previous topic | Next topic ›

Pages: 1

Bin Location (Read 522 times)

TFay Full Member Thanks for the help! Posts: 135	Bin Location 09/21/09 at 08:37:24 Why can't the bin location we entered in IN-B and shows on IN-A not show on PO-C so when we are receiving parts we know where to put them?
Back to top	IP Logged

Lynn_Pantic Administrator evolution (n) - gradual change to a different form Posts: 5663	Re: Bin Location Reply #1 - 09/21/09 at 13:23:20 Do you have Warehouse Control turned on? If you do, it will display the default Bin and allow you to put them there or choose a different bin.
Back to top	Lynn Pantic IS Tech Support lynn@istechsupport.com IP Logged

TFay

Full Member

Thanks for the help!

Posts: 135

Re: Bin Location
Reply #2 - 09/22/09 at 05:50:26

Lynn, After I installed the update, I also turned warehouse control from Q to N. This probably is the issue, but we have had some issues where the Q was forcing us to enter bin locations or asking for bin locations when the part already had one and we only use bin locations for some parts just to help us pull kits.

Can I go back in and set this back to Q?

IP Logged

Pages: 1

ISTech Support Forum › Evo-ERP and DBA Classic › Items

‹ Previous topic | Next topic ›